Product subgroups

Structural devices

Expansion joints, structural bearings and seismic devices are small components with a large responsibility: they allow bridges and buildings to move – under traffic, temperature and earthquakes.

Expansion joints

Subgroup 1

Expansion joints close the gap between the bridge deck and the abutment or between adjacent decks. They carry wheel loads directly, accommodate the movements and rotations caused by temperature, creep, shrinkage and traffic, and protect the structure below from water and de-icing salts – ideally with low noise emission and a long service life.

  • Modular joints
  • Cantilever and supported finger joints
  • Mat joints
  • Nosing joints
  • Flexible plug joints
  • Buried joints
Main function
Bridging the movement gap while carrying traffic
European specification
European Technical Assessment (ETA) based on ETAG 032 “Expansion joints for road bridges”, used as European Assessment Document
Assessment bodies
Technical Assessment Bodies organised in EOTA

Structural bearings

Subgroup 2

Structural bearings transfer vertical and horizontal loads from the superstructure into the piers and abutments. At the same time they allow – or deliberately restrain – displacements and rotations, so that the structure can behave as designed without constraint forces.

  • Elastomeric bearings
  • Pot bearings
  • Spherical and cylindrical bearings
  • Sliding elements
  • Guide and restraint bearings
  • Roller and rocker bearings
Main function
Load transfer with defined displacements and rotations
European standard
EN 1337 “Structural bearings” (Parts 1 to 11: design rules, product types, protection, inspection and maintenance, transport, storage and installation)
Standardisation body
CEN/TC 167 “Structural bearings”

Seismic devices

Subgroup 3

Anti-seismic devices modify the response of a structure to an earthquake: isolators decouple the structure from ground motion, dampers dissipate energy and shock transmission units create rigid connections only under dynamic loads. They are used in bridges as well as in buildings and industrial facilities.

  • Elastomeric isolators
  • Curved surface sliders
  • Fluid viscous dampers
  • Displacement-dependent devices
  • Shock transmission units
  • Rigid connection devices
Main function
Isolation, energy dissipation and controlled load transfer during earthquakes
European standard
EN 15129 “Anti-seismic devices”, applied together with EN 1998 (Eurocode 8)
Standardisation body
CEN/TC 340 “Anti-seismic devices”

Regulatory framework

In the European Union, structural devices are construction products. They are placed on the market with a declaration of performance and CE marking – either on the basis of a harmonised European standard or of a European Technical Assessment.

The legal basis is the Construction Products Regulation (EU) No 305/2011, which is being progressively replaced by the new Construction Products Regulation (EU) 2024/3110. EMASD follows these developments and contributes the practical experience of manufacturers to the drafting of standards and assessment documents.

This overview is for general information only. The current editions of the standards, assessment documents and national provisions are authoritative.

Related organisations